The Super Charging Handle (SCH) is 3D machined from a solid block of aircraft grade 7075-T6 aluminum. Its ambidextrous design allows for seamless operation from either side of the weapon. The levers are dual contoured similar to that of the charging handle of an M14, where not only the x-axis but also the y-axis receive radius cuts. The handling surface of the lever is also checkered, adding a textured grip aiding to the use when operating with gloves. The heightened rear lip of the SCH aids in mitigating gas blow back to the shooter when shooting with short barreled and suppressed weapon systems. All parts are then Type 3 Hardcoat anodized and are available in black and DDC (Desert Dirt Color).
Will not fit Sig 716 or S&W M&P 10 rifles.
The Perfect Piece for Your Retro AR-15
For those fans of the classic retro AR-15 look, Brownells teamed up with Nodak Spud to produce the Brownells Retro AR-15 Triangle Charging Handle.
The Brownells Retro AR-15 Triangle Charging Handle is not an approximation but a carefully researched, detailed replica of the charging handle found on early, much-sought-after "601" rifles issued to the Air Force in the early 1960s. In fact, to distinguish our reproduction from originals, we had to engrave "BRN" hidden away at the bottom to prevent these from being confused with the genuine article.
NOTE: BLEMISHED has small defects in anodized finish. It is functionally sound. You may even prefer one of these to give your rifle replica the "war weary" look.
- Features the correct triangle shape like the originals
- Fits & functions correctly in any standard, current-production mil-spec AR-15 upper receiver
- Constructed of high-grade 6061 T6 aluminum
- "Colt gray" hardcoat anodized finish
If you’re building a 601 replica using our M16A1 upper and lower receivers and reproduction stock/pistol grip/handguard, the Brownells Retro AR-15 Triangle Charging Handle is a must-have component.
Big Book Catalog, Issue:71, Page:035
Easy-To-Grasp Extended Knob Gives Positive Bolt Cycling
Oversize diameter and extended length and give positive bolt control for fumble-free cycling of tactical and benchrest rifles. No more holding the bolt handle with two fingers to clear the scope bell. Provides additional leverage needed to clear stuck rounds. Lightweight aluminum keeps weight down. Installation requires machining and threading of original bolt handle. Mini bolt knob includes ½” wrench for scope removal.
Big Book Catalog, Issue:71, Page:162
SPECS: 7075 T6 aluminum alloy, hardcoat anodized, matte black or gloss red finish. 1½" (4cm) long, .975" (24.7mm) diameter. 1.3 oz. (35 g) weight. Mini - Length – 1.21” Diameter – 0.90” Weight – 0.5 oz Gunsmith installation recommended. 5/16-24 TPI.